Cadillac Fleetwood Recalls — All NHTSA Recall Campaigns

EQUIPMENT

CERTAIN HONEYWELL FRAM RACING BRAND HP4 AND HP8 OIL FILTERS THAT WERE MANUFACTURED FROM MAY 25, 2006, THROUGH SEPTEMBER 14, 2007, AND SOLD FOR USE AS REPLACEMENT EQUIPMENT FOR VEHICLES LIST ABOVE. THE AFFECTED FILTERS ARE MARKED WITH A DATE CODE A61451 THROUGH A72571 SEQUENTIALLY. THE DATE CODE AN…

Risk: THIS CONDITION MAY CAUSE INADEQUATE SEALING AND LOSS OF ENGINE OIL, POSSIBLY RESULTING IN A FIRE.

Remedy: HONEYWELL WILL REPLACE THE AFFECTED OIL FILTERS FREE OF CHARGE. THE RECALL BEGAN DURING NOVEMBER 2007. OWNERS CAN CONTACT FRAM CUSTOMER SERVICE TOLL-FREE AT 1-800-890-2075.

POWER TRAIN:AXLE ASSEMBLY

THE UPPER TRANSAXLE OIL COOLER HOSE CAN PULL OUT OF THE CRIMPED COUPLING AT THE TRANSAXLE END OF THE LINE ASSEMBLY.

Risk: IN THE EVENT OF SEPARATION OF THE COUPLING, AN OIL LEAK CAN OCCUR WHICH, WHEN EXPOSED TO AN IGNITION SOURCE, COULD RESULT IN AN ENGINE COMPARTMENT FIRE.

Remedy: DEALERS WILL INSTALL A NEW UPPER TRANSAXLE OIL COOLER LINE TO THE TRANSAXLE.

AIR BAGS:FRONTAL

THE PASSENGER SIDE AIR BAG CAN EXPERIENCE AN INFLATOR IGNITION DELAY IN THE EVENT OF AN ACCIDENT. THIS DOES NOT COMPLY WITH FMVSS 208, "OCCUPANT CRASH PROTECTION."

Risk: IF THE INFLATOR IGNITION IS DELAYED IN AN ACCIDENT, THEAIR BAG MAY BE LATE IN DEPLOYING, RESULTING IN INCREASED RISK OF INJURY TOTHE PASSENGER SEAT OCCUPANT.

Remedy: REPLACE THE PASSENGER SIDE AIR BAGS.

WHEELS:LUGS/NUTS/BOLTS/STUDS

PAINT ON THE WHEEL MOUNTING SURFACES CAN ACT AS A SHIM BETWEEN THE WHEEL AND THE ROTOR/DRUM. AS THE VEHICLE IS DRIVEN, THE WHEEL IMBEDS INTO THE PAINT, LOOSENING THE LUG NUT AND CAUSING A LOSS OF CLAMP LOAD.

Risk: ONCE CLAMP LOAD IS LOST, ALL TIRE LOADS ARE TAKEN BY THE WHEEL STUDS RESULTING IN A FRACTURE OF THE WHEEL STUDS. THIS COULD CAUSE THE WHEEL TO SEPARATE FROM THE VEHICLE AND COULD RESULT IN A VEHICLES …

Remedy: DEALERS WILL CLEAN THE WHEEL MOUNTING SURFACES FOR ALL FOUR WHEELS. ALSO, THE WHEEL STUDS WILL BE INSPECTED FOR DAMAGE AND WILL BE REPLACED AS NECESSARY.

SUSPENSION:FRONT:CONTROL ARM:LOWER BALL JOINT

DEFECTIVE LOWER CONTROL ARM BALL JOINT ATTACHMENT NUTS WERE NOT PROPERLY TORQUED AND CAN LOOSEN.

Risk: IF THE LOWER CONTROL ARM BALL JOINT LOOSENS, FATIGUES AND SEPARATES FROM THE FRONT SUSPENSION KNUCKLE, IT COULD CAUSE LOSS OF VEHICLE CONTROL.

Remedy: DEALERS WILL INSPECT BOTH FRONT LOWER CONTROL ARM BALL JOINT ATTACHMENT NUTS FOR PROPER TORQUE. IF THE BALL JOINT HAS LOOSENED FROM THE KNUCKLE, BOTH THE BALL JOINT AND THE KNUCKLE WILL BE REPLACED.

ENGINE AND ENGINE COOLING:COOLING SYSTEM:HOSES/LINES/PIPING/FITTINGS

THE ENGINE OIL COOLER INLET HOSE MAY HAVE BEEN INSTALLED TOO CLOSE TO THE STEERING GEAR CAUSING CHAFING. THE CHAFING CAN EVENTUALLY WEAR THROUGH THE HOSE'S PROTECTIVE SLEEVE RESULTING IN ENGINE OIL LEAKING ONTO THE ENGINE.

Risk: IF THIS OCCURS, THE OIL LEAK ONTO THE ENGINE CAN RESULT IN AN ENGINE COMPARTMENT FIRE.

FUEL SYSTEM, GASOLINE:STORAGE:TANK ASSEMBLY:MOUNTING

THE FUEL TANK ATTACHMENT STRAP FASTENERS WERE NOT PROPERLY TIGHTENED. THE FASTENERS CAN COMPLETELY DETACH, EVENTUALLY ALLOWING THE FUEL TANK TO SAG AND THE BOTTOM OF THE TANK TO STRIKE THE ROADWAY.

Risk: THIS CAN RESULT IN A FUEL TANK LEAK AND FIRE IF THE LEAKING FUEL IS EXPOSED TO A SOURCE OF IGNITION.

Remedy: DEALERS WILL RETIGHTEN THE FUEL TANK STRAP FASTENERS.

VEHICLE SPEED CONTROL:SPRINGS

THESE VEHICLES FAIL TO CONFORM TO FMVSS NO. 124, "ACCELERATOR CONTROL SYSTEMS." AT LOW TEMPERATURES, EXCESSIVE FRICTION CAN OCCUR IN THE ACCELERATOR PEDAL ASSEMBLY.

Risk: CONSEQUENCE OF NON-COMPLIANCE: IN THE EVENT OF A FAILURE OF THE TROTTLE RETURN SPRING, IF THERE IS EXCESSIVE FRICTION IN THE PEDAL ASSEMBLY, THE ENGINE SPEED MAY NOT RETURN TO IDLE INCREASING THE POT…

Remedy: DEALERS WILL REPLACE THE ACCELERATOR PEDAL ASSEMBLY.

POWER TRAIN:AUTOMATIC TRANSMISSION

THESE VEHICLES WERE PRODUCED WITH AN IMPROPERLY ADJUSTED TRANSMISSION SHIFT CONTROL LINKAGE. THIS DOES NOT MEET WITH THE REQUIREMENTS OF FMVSS NO. 114, "THEFT PROTECTION."

Risk: CONSEQUENCE OF NON-COMPLIANCE: IT MAY BE POSSIBLE TO SHIFT FROM THE "PARK" POSITION WITH THE IGNITION KEY REMOVED INCREASING THE RISK OF A VEHICLE ACCIDENT RESULTING FROM THE UNINTENDED MOVEMENT OF A…

Remedy: DEALERS WILL ADJUST THE SHIFT CONTROL LINKAGE SYSTEM.

WHEELS:LUGS/NUTS/BOLTS/STUDS

THE WHEEL LUG NUTS WERE NOT TIGHTENED TO THE PROPER SPECIFICATION DURING ASSEMBLY.

Risk: THIS CONDITION COULD RESULT IN A FRACTURE OF THE WHEEL STUDS CAUSING THE WHEEL TO SEPARATE FROM THE VEHICLE.

Remedy: DEALERS WILL TIGHTEN THE VEHICLE'S WHEEL LUG NUTS TO THE PROPER SPECIFICATION.

SUSPENSION:FRONT:CONTROL ARM:LOWER BALL JOINT

DEFECTIVE LOWER CONTROL ARM BALL JOINT ATTACHMENT NUTS WERE NOT PROPERLY TORQUED AND CAN LOOSEN.

Risk: THE LOWER CONTROL ARM BALL JOINT CAN LOOSEN, FATIGUE, AND SEPARATE FROM THE FRONT SUSPENSION KNUCKLE RESULTING IN A LOSS OF VEHICLE CONTROL.

Remedy: DEALERS WILL INSPECT BOTH FRONT LOWER CONTROL ARM BALL JOINT ATTACHMENT NUTS FOR PROPER TORQUE. IF THE BALL JOINT HAS LOOSENED, BOTH THE BALL JOINT AND THE KNUCKLE WILL BE REPLACED.