1990 Volkswagen Jetta — Problems, Recalls & Complaints

SABERSPORT IS RECALLING 16,270 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.

Remedy: SABERSPORT WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON MAY 11, 2009. OWNERS MAY CONTACT SABERSPORT AT 1-909-598-7589.

CERTAIN HYDRAULIC BRAKE HOSES, P/N 171.611.107B, SOLD AS REPLACEMENT EQUIPMENT FOR 1975-1985 VOLKSWAGEN (VW) RABBIT; 1985-1992 VW GOLF; AND 1980-1992 VW JETTA PASSENGER VEHICLES. POSSIBLE BRAKE HOSE RUPTURE COULD OCCUR WHICH FAILS TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 106, "BRAKE HOSES."

Remedy: FOREIGN PARTS DISTRIBUTORS WILL NOTIFY OWNERS AND REPLACE THE BRAKE HOSES WITH COMPLIANT BRAKE HOSES. THE RECALL BEGAN ON MARCH 30, 2006. OWNERS MAY CONTACT FOREIGN PARTS DISTRIBUTORS AT 305-885-8646 EXT. 11.

THE FUEL HOSE ATTACHED TO THE FUEL DISTRIBUTION RAIL ON THE ENGINE MAY SHRINK BEYOND THE CLAMP FORCE OF THE FUEL HOSE CLAMPS, ALLOWING FUEL TO LEAK.

Remedy: REPLACE THE FUEL HOSE ATTACHED TO THE FUEL RAIL AND INSTALL A NEW SPRING TYPE SELF-TIGHTENING CLAMP.

OMISSION OF AIR DUCTS INTENDED TO GUIDE FLOW OF COOLING AIR TO LEFT AND RIGHT FRONT BRAKE CALIPERS COULD ALLOW BRAKE FLUID TO EXCEED ALLOWABLE OPERATING TEMPERATURE UNDER CERTAIN OPERATING CONDITIONS.

Remedy: INSTALL MISSING LEFT AND RIGHT FRONT AIR DUCTS.

AN ENGINE PREHEATING TUBE MAY NOT BE PROPERLY SUPPORTED DUE TO A MISSING SUPPORT BRACKET, CAUSING THE PREHEATING TUBE TO CHAFE AGAINST THE RIGHT FRONT METAL BRAKE LINE. THIS CAN DAMAGE THE HYDRAULIC LINE, CAUSING BRAKE FLUID LEAKAGE AND DIMINISHED BRAKING IN ONE BRAKE CIRCUIT.

Remedy: DEALERS WILL INSTALL A PREHEATING TUBE SUPPORT BRACKET TO ENSURE PROPER POSITIONING RELATIVE TO THE RIGHT FRONT METAL BRAKE LINE.

POWER STEERING PUMP BRACKET IS SUBJECT TO BREAKAGE DUE TO EXCESSIVE TENSION CAUSED BY A LACK OF CLEARANCE BETWEEN THE PUMP MOUNTING BRACKET AND SEALING FLANGE EDGE OF THE OIL PAN.

Remedy: REPLACE POWER STEERING PUMP BRACKET.

THE END CAP CONNECTING THE HEAT EXCHANGER'S CORE TO THE ENGINE COOLING SYSTEM COULD RUPTURE AND ALLOW HOT COOLANT TO ESCAPE INTO THE PASSENGER COMPARTMENT.

Remedy: REPLACE THE HEATER CORE WITH AN IMPROVED HEATER CORE.