1994 Oldsmobile Cutlass Ciera — Problems, Recalls & Complaints

IN THE EVENT OF A PRIMARY ACCELERATOR CONTROL SPRING FAILURE, THE SECONDARY (BACK-UP) ACCELERATOR CONTROL RETURN SPRING WILL NOT RETURN THE THROTTLE TO THE FULLY CLOSED POSITION, AS REQUIRED BY FMVSS NO. 124, "ACCELERATOR CONTROL SYSTEM."

Remedy: DEALERS WILL REPLACE THE SECONDARY THROTTLE RETURN SPRING.

THE RIGHT HAND SPINDLE NUT WAS NOT PROPERLY TIGHTENED DURING ASSEMBLY. THIS CAN CAUSE PREMATURE WHEEL BEARING FAILURE AND OVER TIME, THE SPINDLE CAN FRACTURE.

Remedy: DEALERS WILL INSPECT THE TORQUE ON THE RIGHT HAND FRONT SPINDLE NUT. IF THE SPINDLE NUT IS UNDERTORQUED THE DEALER WILL REPLACE THE RIGHT HAND FRONT WHEEL BEARING ASSEMBLY AND THE SPINDLE NUT WILL BE REPLACED.

WATER INTRUSION CAN CAUSE A SHORT CIRCUIT IN THE POWER DOOR LOCK ASSEMBLY.

Remedy: DEALERS WILL REPLACE THE POWER DOOR LOCK RELAY AND ANY CORRODED TERMINALS. IN ADDITION, THE NEW RELAY WILL BE RELOCATED TO AN AREA WHERE WATER INTRUSION IS LESS LIKELY.

THESE VEHICLES WERE ASSEMBLED WITH REAR OUTBOARD SAFETY BELT ANCHORAGES THAT MAY NOT WITHSTAND THE REQUIRED LOAD. THIS DOES NOT COMPLY WITH FMVSS NO.210, "SEAT BELT ASSEMBLY ANCHORAGES."

Remedy: DEALERS WILL REPLACE THE EXISTING ANCHOR BOLTS WITH A NEW SHOULDER BOLT AND THREAD LOCKING ADHESIVE. ADDITIONALLY, NOISE CONTROL PATCHES WILL BE APPLIED AT EACH ANCHORAGE.