1999 Land Rover Range Rover — Problems, Recalls & Complaints

VEHICLE DESCRIPTION: SPORT UTILITY VEHICLES. THE CAST ALLOY THROTTLE BODY IS HEATED BY FLUID BLED FROM THE COOLING SYSTEM, TO PREVENT ICING IN EXTREMELY COLD WEATHER CONDITIONS. THIS FLUID PASSES THROUGH A SMALL ATTACHMENT (PLATE) TO THE THROTTLE BODY, WHICH UTILIZES A CORK GASKET. THE CORK GASKET HAS PROVEN TO BE UNRELIABLE IN THIS APPLICATION. CONSEQUENTLY, COOLANT FLUID CAN LEAK FROM THE INTERFACE BETWEEN THE DE-ICER PLATE AND THE THROTTLE BODY.

Remedy: DEALERS WILL REPLACE THE THROTTLE BODY GASKET, DE-ICER ATTACHMENT, AND SECURING HARDWARE.

VEHICLE DESCRIPTION: SPORT UTILITY VEHICLES. COOLANT SYSTEM LEAKS HAVE BEEN IDENTIFIED IN AREAS WHERE THE COOLANT COULD BE SUBJECTED TO ELEVATED TEMPERATURES.

Remedy: DEALERS WILL MAKE A SERIES OF MODIFICATIONS TO SEVERAL UNDERHOOD HOSE COMPONENTS TO ELIMINATE THE RELEASE OF ENGINE COOLANT.

VEHICLE DESCRIPTION: CERTAIN SPORT UTILITY VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FMVSS NO. 114, "THEFT PROTECTION." WATER CONTAMINATION OF THE AUTOMATIC TRANSMISSION OIL CAN LEAD TO VARIOUS FAILURE MODES OF THE TRANSMISSION. ONE OF THESE FAILURE MODELS RESULTS IN INCORRECT OPERATION OF THE PARK LOCK FUNCTION THAT COULD ALLOW A VEHICLE TO ROLL AWAY IF PARKED WITHOUT THE HANDBRAKE PROPERLY SET.

Remedy: DEALERS WILL CHECK THE PARK LOCK FUNCTION; REPOSITION THE AUTOMATIC TRANSMISSION BREATHER TUBE; AND TEST THE AUTOMATIC TRANSMISSION FLUID AND FLUSH IF NECESSARY.

VEHICLE DESCRIPTION: SPORT UTILITY VEHICLES. THE LOADING CONDITIONS ON THE VEHICLE'S LEFT SIDE ENGINE IDLER PULLEY CAN EXCEED THE MAXIMUM CALCULATED FIGURE OF THE ORIGINAL DESIGN SPECIFICATION. THE MATERIAL OF THE PULLEY CAN FRACTURE AND ULTIMATELY FAIL. FAILURE OF THE PULLEY MATERIAL CAN CAUSE THE PULLEY TO THROW OFF THE SERPENTINE BELT.

Remedy: DEALERS WILL INSTALL AN IMPROVED IDLER PULLEY.

VEHICLE DESCRIPTION: SPORT UTILITY VEHICLES. AS A RESULT OF WATER INGRESS AND SUBSEQUENT ICE BLOCKAGE, THE TRANSMISSION BREATHER TUBE CAN BECOME CLOGGED, EXPELLING TRANSMISSION FLUID FROM THE DIPSTICK TUBE ONTO HOT ENGINE COMPONENTS.

Remedy: DEALERS WILL REMOVE THE TRANSMISSION BREATHER TUBE FROM THE INNER FENDER AND A SECTION OF THE HOSE WILL BE CUT AT AN ANGLE. THIS ACTION WILL REMOVE THE END OF THE BREATHER TUBE FROM ANY POOLED WATER AND WILL ELIMINATE WATER DROPLETS FROM CLINGING TO THE END OF THE TUBE.