1996 Buick Skylark — Problems, Recalls & Complaints

ON CERTAIN PASSENGER VEHICLES. IF THE ENGINE FAILS TO START AND THE DRIVER HOLDS THE KEY IN THE "START" POSITION FOR AN EXTENDED PERIOD, HIGH CURRENT FLOWS THROUGH THE IGNITION SWITCH, AND SOMETIMES PRODUCES ENOUGH HEAT TO MELT INTERNAL SWITCH PARTS.

Remedy: DEALERS WILL INSTALL A RELAY KIT IN THESE VEHICLES TO PREVENT HIGH CURRENT FROM FLOWING THROUGH THE IGNITION SWITCH. OWNER NOTIFICATION BEGAN MARCH 27, 2002. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT CHEVROLET AT 1-800-222-1020, PONTIAC AT 1-800-762-2737, BUICK AT 1-800-521-7300, OR OLDSMOBILE AT 1-800-442-6537.

CERTAIN DELPHI FUEL PRESSURE REGULATORS, P/NOS. FP10020-11B1, FP10026-11B1, AND FP10027-11B1, SOLD AFTER JANUARY 9, 2007, AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES LISTED ABOVE. THE UNIVERSAL PRESSURE REGULATORS (UPR) WERE PRODUCED WITHOUT AN O'RING AND RETAINER.

Remedy: DELPHI WILL NOTIFY OWNERS AND REPLACE THE UPR FREE OF CHARGE. THE RECALL BEGAN ON APRIL 23, 2007. OWNERS CAN CONTACT DELPHI AT 877-411-8770.

CERTAIN DELPHI AFTERMARKET FUEL PUMP MODULES / MODULE RESERVOIR ASSEMBLIES (MRA) THAT WERE SOLD FOR USE ON THE ABOVE LISTED VEHICLES. DURING PRODUCTION THE MRAS VENT AND FUEL RETURN TUBES WERE REVERSED. THIS CONDITION CAN RESULT IN THE VEHICLE NOT RUNNING CORRECTLY (IDLE ROUGH AND/OR STALL) DUE TO AN OVERLY RICH FUEL BLEND OR THE VEHICLE'S EVAPORATIVE EMISSION CARBON CANISTER MAY LEAK FUEL.

Remedy: DELPHI WILL NOTIFY OWNERS AND REPLACE THE DEFECTIVE MRAS FREE OF CHARGE. THE RECALL BEGAN ON MARCH 20, 2007. OWNERS CAN CONTACT DELPHI AT 1-877-335-7443.

THE STEERING COLUMN LOWER PINCH BOLT WAS NOT PROPERLY TIGHTENED DURING ASSEMBLY.

Remedy: DEALERS WILL INSPECT THE STEERING COLUMN PINCH BOLT FOR CORRECT TORQUE AND, IF NECESSARY, TIGHTEN THE BOLT TO THE SPECIFIED TORQUE.

VEHICLE DESCRIPTION: PASSENGER VEHICLES. THESE VEHICLES WERE BUILT WITH THE POTENTIAL FOR THE INTERIOR LAMPS TO COME ON UNEXPECTEDLY WHILE THE VEHICLES ARE BEING DRIVEN. THIS DOES NOT MEET THE REQUIREMENTS OF FMVSS NO. 101, "CONTROLS AND DISPLAYS."

Remedy: DEALERS WILL RUN A DIAGNOSTIC TEST ON THE LAMP CONTROL MODULE AND, IF NECESSARY, REPLACE IT.

DURING DEPLOYMENT OF THE PASSENGER AIR BAG, THE AIR BAG FABRIC CAN SNAG ON A REINFORCEMENT INSIDE THE INSTRUMENT PANEL, CAUSING THE EXPANDING AIR BAG TO LIFT THE INSTRUMENT PANEL PAD AND THEN DEPLOY UNDER THE INSTRUMENT PANEL INSTEAD OF THROUGH THE DOOR IN THE INSTRUMENT PANEL.

Remedy: DEALERS WILL INSPECT THE INSTRUMENT PANEL PADS AND, IF NECESSARY, INSTALL A PLASTIC EDGE PROTECTOR TO THE INSTRUMENT PANEL PAD REINFORCEMENT. ON CERTAIN EARLY-PRODUCTION VEHICLES, THE INSTRUMENT PANEL PAD WILL BE REPLACED.